Can't connect to target TC275TP-64 F200N

dumitru
New Member

Posts: 3

Can't connect to target TC275TP-64 F200N Mar 5, 2019 8:14:38 GMT

Quote

Hello,

I just got my board and I am trying to use it.

While using the Arduino IDE, when Infineon Memtool is called,

it says:

"Controller0.Core0 - Can't establish Connection to Target"

I don't think it's a power supply issue.

I tried several USB cables, I also tried an external power supply

(after switching the jumper).

The one thing that seems different from other posts here

is the version of the TriCore chip I got from RadioSpares,

which is:

TC275TP-64 F200N

It does not fit exactly any of the chip identifiers in the

Arduino list, nor those of Infineon Memtool.

Please, advise.

Best,

Dumitru

Admin Administrator Posts: 711	Can't connect to target TC275TP-64 F200N Mar 5, 2019 8:23:24 GMT dumitru likes this Quote Select Post Deselect Post Link to Post Back to Top Post by Admin on Mar 5, 2019 8:23:24 GMT Does the processor have a "DC" or "CA" marking on it? If it is "DC" then please select the board type "ShieldBuddy TC275 Dx".

dumitru New Member Posts: 3	Can't connect to target TC275TP-64 F200N Mar 5, 2019 8:42:58 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by dumitru on Mar 5, 2019 8:42:58 GMT Problem solved - I simply had to set the type of my board to TC275_Dx...

dumitru New Member Posts: 3	Can't connect to target TC275TP-64 F200N Mar 5, 2019 8:44:46 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by dumitru on Mar 5, 2019 8:44:46 GMT Mar 5, 2019 8:23:24 GMT Admin said: Does the processor have a "DC" or "CA" marking on it? If it is "DC" then please select the board type "ShieldBuddy TC275 Dx". Yes. "DC" is written at the very end. What does it mean ? Dumitru

Admin Administrator Posts: 711	Can't connect to target TC275TP-64 F200N Mar 5, 2019 9:03:26 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by Admin on Mar 5, 2019 9:03:26 GMT This is the revision of the TC275 silicon.