|
|
Post by ptqfp144 on Dec 19, 2016 17:22:45 GMT
After reading the AurixUnleased document I was trying to run the iLLD_GtmTomTimerDemo. To open the project I ran : Hightec - File - Import - General - Existing project into workspace. Attached the error I get when building. Any help appreciated.  |
|
|
|
Post by ptqfp144 on Dec 19, 2016 18:27:58 GMT
Same result when doing :
Hightec - File - New - Make file project with existing code.
|
|
|
|
Post by ptqfp144 on Dec 20, 2016 13:08:43 GMT
On the infineon site video : iLLD_Demos_HowTo.avi gives instructions to run the iLLD demo's.
Is this really the easyest way to run the Demo's ?
The procedure is rather lengthy and quite obscure for me since I'm not familiar with most of the tools.
|
|
|
|
Post by mjb on Dec 20, 2016 13:33:38 GMT
|
|
|
|
Post by ptqfp144 on Dec 20, 2016 17:02:12 GMT
Thanks , working on it. Think I've the working free hightec compiler tools properly installed. But when checking this the Kit_TC297_TFT failed to be programmed again ... This I resolved with the information on the infineon forum about that problem , moved resistor from position R128 to R127.  |
|
|
|
Post by mjb on Dec 21, 2016 8:19:26 GMT
Sorry, I am confused! I thought you were using the ShieldBuddy! It sounds like you are having problems with the TLE35584 resetting the TC297.
|
|
|
|
Post by dave6666 on Dec 21, 2016 9:22:23 GMT
Hello, yes this is putting the smart regulator of the TFT board into 'Flashing Mode'. In it's normal mode this device requires a 'kick' from the TC2xx over SPI. The ShieldBuddy does not use this regulator!
|
|
|
|
Post by mjb on Dec 21, 2016 9:24:27 GMT
We tried to keep the ShieldBuddy simple! It does have an equivalent safety monitor feature if you solder down a CIC61508 and this has been used with the SafeTLib.
|
|
|
|
Post by ptqfp144 on Dec 21, 2016 23:02:51 GMT
Sorry, I am confused! I thought you were using the ShieldBuddy! It sounds like you are having problems with the TLE35584 resetting the TC297. Sorry mjb , I'm also working with the shieldbuddy but tested some examples to see if the hightec environment was still ok. Then I found out the TC297 board wasn't prgrammable anymore , then shifted focus to resolve this first. Lot of other work overhere so I can't do much ; even these days. |
|
