|
Post by maxthemagnificent on Mar 29, 2020 0:19:27 GMT
I just took delivery of a ShieldBuddy
I'm using the Arduino IDE
I created a simple program to flash a LED on a breadboard - -I tested the program using an Arduino Uno on Com Port 7 -- then I swapped the Uno for the ShieldBuddy on Com Port 5.
When I click the compile/upload button, the program compiles, but when it gets to the upload, a window pops up with the title "Infineon - Memtool on TriBoard with TC275/TC277 CStep (DAS). Then another window pops up with the title Controller0.Core0 - Can't establish Connection to Target.
Any ideas?
One thing is that the instructions in the manual say:
1) Load the Aurix Tool Chain 2) Load the Arduino IDE 3) Load the Arduino Development add-in for Eclipse
They also say to do things in this order
The problem is that I, like a lot of users, already have the Arduino IDE installed, so I just did steps 1 and 3 -- do I need to uninstall the Arduino IDE and then perform steps 2 and 3?
|
|
|
Post by maxthemagnificent on Mar 29, 2020 0:42:44 GMT
I tried swapping the board to be the ShieldBuddytC275_Dx in the Arduino IDE and that worked (phew!)
On to the next challenge :-)
|
|