jimmie
Junior Member
Posts: 86
|
Post by jimmie on Jun 25, 2019 9:59:33 GMT
When attaching devices to the Shieldbuddy pins, are those pins 5V tolerant or only 3.3?
The Arduino Mega is 5V tolerant whereas the Due is only 3.3V (as I understand it).
It is odd that despite an extensive search I could not find anything helpful on such an important issue which could destroy a relatively expensive board!
I hope the community can shed some light and thanks in advance.
|
|
jimmie
Junior Member
Posts: 86
|
Post by jimmie on Jul 6, 2019 9:55:46 GMT
I am having second thoughts about this board.
I have already purchased it and it is on its way. It is vital on any board to find out if pins are 5V tolerant or not.
It is one thing not to get a response from a volunteer community forum, however I have already written to both Infineon and Hitex but yet to hear back anything.
VERY POOR SERVICE.
ADMIN: We are sorry you did not get a reply directly from Hitex or Infineon. For ShieldBuddy questions, it is always best to go via the forum as this is monitored by Hitex at least once every 48 hours. Unfortunately there are no direct Hitex email addresses to use for this board. We hope you are successful in your project!
|
|
|
|
Post by Admin on Jul 6, 2019 12:02:11 GMT
All Shieldbuddy pins are 5v.
|
|
jimmie
Junior Member
Posts: 86
|
Post by jimmie on Jul 8, 2019 3:53:57 GMT
THANK YOU.
|
|
