|
Post by austbots on Nov 15, 2022 14:36:02 GMT
Hello,
First time with ShieldBuddy.
1. Have installed Arduino IDE. 2. Have installed free tool chain. 3. Have installed IDE.
I can compile an example OK - license works.
Arduino recognizes the board as TC375 under the Adrduino category.
Device manager sees board on com 4 as Infineon DAS JDS COM
Device manager sees board as USB Infineon DAS JDS COM and DAS JDS DEBUG
I have tried different USB cables and have powered the board with 12V and without external power.
I feel I am close...
When I download, window opens and then error window opens and says;
Message from component 'IMTMemtool' :
Can't connect to Target
Message from component 'Controller0.Core0.Tc2CoreTargIntf' :
Can't connect target !
Message from component 'Controller0.Core0.Tc2CoreTargIntf' :
Can't connect JTAG target
Message from component 'Controller0.Core0.Tc2CoreTargIntf' :
Executing init commands failed
Please check init commands
Any help appreciated - is the board still supported?
|
|
|
Post by austbots on Nov 16, 2022 0:28:57 GMT
Had a look this morning, even though my board appears as a TC375, the label on the chip says TC275.
1. How do I determine which board I actually have? 2. What do I do differently if it is a TC275?
Do, I need to reinstall all of the sofwtare? Or do I just need to change the Arduino config?
How do I change the Arduino config?
|
|
|
Post by juanjqh on Nov 17, 2022 19:19:16 GMT
Have you tried changing the board configuration in the arduino ide to the ShieldBuddy_Dx or ShieldBuddy board? I am looking at the error message of the tool and it is detecting that you have a TC275 and not a TC375!
|
|
|
Post by Admin on Nov 21, 2022 8:16:31 GMT
Looks like you have a ShieldBuddy TC275. Please use the ShieldBuddy_Dx board type. ALmost all current ShieldBuddies are the DC step type.
|
|